Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why San Francisco Homeowners Choose Tremron Construction
Tremron hardscape products are a common sight across Tremron in San Francisco, and for good reason: they offer a clean, modular look that suits both the city’s historic Victorians and its mid-century stucco boxes. We are an independent Tremron service provider, not a manufacturer-authorized dealer, which means we give you straight answers about where these products hold up, where they fail, and what a repair actually costs in this city’s specific soils. Curtis Lane and our crews at Bradford Remodeling Co San Francisco have worked with Tremron masonry since the early 2000s. We know which lines survive the Richmond’s sand dunes and which ones crack under Noe Valley’s clay. Call (831) 610-5598 to discuss your Tremron project or repair with a real person.
Here’s the straight number up front: Tremron hardscape work in San Francisco runs from about $4,130 for a modest paver patio to $21,240 for a full paver driveway rebuild. Roof repair, which often accompanies hardscape work when drainage fails, lands between $470 and $2,125. Every job gets a written price before we start. That is the Bradford standard.
Why Trust Bradford Remodeling Co San Francisco for Your Tremron Construction?
Curtis Lane grew up swinging a framing hammer in Los Angeles and trained at Los Angeles Trade-Technical College, where he learned to read structural drawings and run material takeoffs properly before he ever billed a client. Two decades later, he has spent years working through San Francisco’s specific headaches: fog-driven moisture in the Outer Sunset, shifting fill in the Excelsior, and steep lots where water pressure behind a retaining wall will crack the block if nobody weeps it. When we show up to inspect your Tremron pavers or wall, we are looking at your soil, your drainage, and your base prep before we touch a single unit. That is the difference between a repair that lasts and one that fails next winter.
Every Tremron job we take gets a written scope. The price does not move at the door. The crew arrives background-checked and uniformed. And the work carries our 365-Day Done Right Promise: if the repair or install fails within one year, we return and correct it at no charge. The Garrison Standard is not a slogan to us. It is the framework we operate under as part of the Garrison Partners family since 2004. Straight number, real scope, no surprises at close-out.
Styles & brands we work with
Common Tremron Construction Problems We Fix in San Francisco
San Francisco’s soils are not uniform. The Richmond and Sunset sit on sand dunes. The Excelsior, Outer Mission, and Bernal Heights sit on expansive adobe clay. The same Tremron product behaves differently on each. Here are the issues we actually see:
- Rutting and differential settlement in Mega Olde Towne driveways. On sandy dune soils near Ocean Beach and Park Merced, a thin base or poor compaction lets the load-bearing wheel lane sink. We have seen driveways rut two inches under a single garbage-truck turn. The fix is a proper excavation, geotextile separation, and recompaction in lifts, not just re-leveling sand.
- Efflorescence and color fading on Bristol Slate pavers. Shaded hillside yards in neighborhoods like Glen Park hold moisture in the joints all season. Water moves through the paver, carries salts to the surface, and leaves a cloudy white film. The clouding is cosmetic but the trapped moisture is not. We correct drainage and joint permeability so the cycle stops.
- Edge restraint failure on Geneva slab patios. In the Excelsior and Outer Mission, expansive adobe clay expands and contracts through every wet-dry season. If the edge restraint is a flimsy plastic strip, the outside course pushes out and the whole field loses lock. We rebuild edges with concrete haunching that actually resists lateral movement.
- Cracked corner units on Castillo retaining walls. On steep Bernal Heights lots, water builds up behind unweeping walls and hydrostatic pressure splits the block at its thinnest point: the corner. We add weep holes, drainage aggregate, and rebuild the affected section with new units rather than patching a structural crack.
- Chipped and spalled pavers from freeze-thaw and traffic. Once a paver loses more than 30% of its thickness through the face shell, patching is a waste of your money. We replace the unit with a factory-color-matched Tremron piece when available, or mill and color-match locally for discontinued lines.
Tremron Parts & Our Repair-vs-Replace Approach
We source factory-color-matched Tremron replacement units by batch number whenever the manufacturer still runs that line. Batch numbers matter because pigment blends shift slightly between production runs; a paver from a different batch will show up as a color blotch in your patio. For discontinued Tremron colors, we mill local basalt or Sonoma fieldstone to match size and tone within 1/8 inch. It is slower than buying a close-enough box off the shelf, but it means the repair does not look like a patch job.
Our repair-vs-replace rule is simple. If a paver has lost more than 30% of its thickness, or a wall block has spalled through its face shell, we replace the unit. Patching a structurally compromised unit just guarantees the next freeze-thaw cycle recreates the same crack. If the base is sound and the unit is intact, we repair and re-set. We do not upsell a full rebuild when the existing base is doing its job. Call (831) 610-5598 and we will tell you which situation you are in.
Our Tremron Service Process – Step by Step
Every Tremron job in San Francisco runs on a fixed sequence. No skipped steps, no “we will figure that out on site.”
- 1
Site walk and soil assessment. We excavate a test pit at the project’s low point and visually classify your soil: sand, clay, or fill. This determines the base spec before any paver is touched.
- 2
Diagnosis and written scope. We identify the failure mode (base failure, edge failure, drainage failure, or unit failure), document it, and put a written price and scope in your hand. The price does not change at the door.
- 3
Excavation and base prep. We excavate to the depth that matches your soil, not the depth that matches a generic spec sheet. In San Francisco that often means going deeper than a flatlands contractor would.
- 4
Compaction in lifts with geotextile where needed. We recompact in 3-inch lifts at 95% Proctor. On sand dune soils, we add Mirafi geotextile to separate the subgrade from the base aggregate.
- 5
Paver or wall install with correct joint spec. We relay Tremron units at the correct joint width, using the right bedding material and edge restraint for the product line and slope.
- 6
Load and drainage test. After install, we run water over the surface and check lateral movement on slopes. The job is not done until the drainage works and nothing shifts.
- 7
Walkthrough and written guarantee. You get a signed copy of the 365-Day Done Right Promise before we leave the site.
See the difference
Before
After
Before
After
Before
AfterTremron Products We Service & Install in San Francisco
We work primarily with four Tremron product lines in Tremron in San Mateo and San Francisco: Mega Olde Towne Pavers (driveways and heavy-load areas), Bristol Slate Pavers (patios and walkways with a slate-textured finish), Geneva Slab Pavers (large-format patios and plazas), and Castillo Wall Block (retaining walls and seat walls). We keep a stock of common replacement units for the Mega Olde Towne and Geneva lines locally, which shortens turnaround on repairs. For Bristol Slate and Castillo, we order by batch number and schedule the work accordingly.
We Also Service These Brands
Tremron is one manufacturer, not the whole hardscape world. We also install and service Belgard and Unilock pavers, and our broader construction crews handle KraftMaid cabinetry, Cambria and Silestone countertops, and Kohler fixtures. If your project spans hardscape and interior remodeling, working with a single General Contractor means one call handles both.
FAQs – Tremron Construction Service in San Francisco
No. We are an independent Tremron service provider with two decades of hands-on experience installing and repairing their products in San Francisco’s specific soils. We are not a manufacturer-authorized dealer, and we do not claim to be. What we claim is direct experience with which Tremron lines hold up on dune sand versus adobe clay, and we put that in writing before any work starts.
Yes, whenever the line is still in production and the batch can be matched. For discontinued Tremron colors, we mill local stone to match size and tone within 1/8 inch. We do not sell aftermarket “Tremron-style” units because they never match the original color or texture. Call (831) 610-5598 to confirm whether your line is still available.
Most single-area repairs, like a sinking corner or a cracked edge course, are done in one to two days. A full paver driveway rebuild typically runs one to two weeks depending on excavation depth and weather. San Francisco’s fog and marine layer can shrink the exterior work window, so we sequence excavation and compaction around dry days when possible.
We service and install Mega Olde Towne Pavers, Bristol Slate Pavers, Geneva Slab Pavers, and Castillo Wall Block. These four lines cover most driveways, patios, walkways, and retaining walls we encounter in San Francisco. If you have a Tremron product outside these lines, call us; we will tell you honestly whether we are the right crew for it.
Any manufacturer warranty on Tremron units covers defects in the unit itself, not site conditions or installation. Repairs we perform do not alter the manufacturer’s unit warranty because we are not modifying the pavers themselves, we are correcting the base, drainage, or edge conditions around them. If the work we do fails within one year, our 365-Day Done Right Promise covers the repair at no charge, regardless of the manufacturer’s position.
Paver driveway installation runs $8,260 to $21,240 depending on size, excavation depth, and whether we are working on sand or clay. Paver patio installation runs $4,130 to $12,980. Roof repair, which often ties into drainage problems that damage hardscape below, runs $470 to $2,125. Every quote is a written line-item price before work begins. Call (831) 610-5598 for an exact estimate on your specific site.
Book Your Tremron Service in San Francisco, CA
We service Tremron hardscape across the city, from the sand dune lots of the Sunset and Richmond to the clay hillsides of the Excelsior, Noe Valley, and Bernal Heights, and we also provide Tremron service in Oakland. One call gets you a straight diagnosis and a written price. Call Bradford Remodeling Co San Francisco at (831) 610-5598 to schedule your free estimate.
Written by Curtis Lane, Owner at Bradford Remodeling Co San Francisco, serving San Francisco since 2004.
