A Bradford company - serving San Francisco, CA
A new rear addition with a vaulted beamed ceiling and tall windows

Dvele Driveway & Pavers Nationwide

Free Estimate on SiteCalls Answered by a Live Person, 24/7Background-Checked TechniciansA Local Team in San Francisco
A wide opening with a new beam where the kitchen wall was removed
A garage converted into a guest room and home office
A built-in window seat in a bay window
A dining nook with a built-in banquette
A home office with a built-in desk and shelves
A remodeled kitchen with a waterfall island and wood cabinets
A wood double vanity with two mirrors after a bathroom remodel
An open living space after a whole-home remodel
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

Your dream remodel for as low as$199/month*On approved credit; ask for current terms
Get your free estimate

Dvele Driveway & Pavers: The San Francisco Owner’s Guide

Dvele-compatible driveway and paver work in San Francisco typically runs $8,260 to $21,240 installed, depending on square footage, substrate condition, and drainage requirements. We stock Belgard paver lines that match Dvele’s clean, horizontal aesthetic, and our crews install them on a written, fixed-price scope. Here’s the situation we see most often: a Dvele owner notices a paver settling or a seam pulling apart near the garage approach, and what starts as a trip hazard becomes a drainage problem within one wet season. San Francisco’s freeze-thaw cycles are mild compared to Truckee, but the real enemy here is water. Clay-heavy soil in neighborhoods like the Sunset and Richmond holds moisture against the paver base, and when the base washes out, the surface follows. We fix that at the substrate level, not by resetting a few pavers and hoping.

Call (831) 610-5598

Which Dvele Models This Applies To

Dvele’s homes ship with a consistent hardscape package across their model lines, so if your home was built after 2019 you’re most likely working with a 24-inch by 24-inch concrete paver or a modular 16-inch by 16-inch unit in a light gray or warm taupe finish. The compatibility gotcha: Dvele specs a tighter joint width than most production builders (typically 1/8 inch to 3/16 inch), which means the polymeric sand you use matters. Standard big-box sand will crack out within a season. We use manufacturer-matched jointing compound rated for San Francisco’s wet winters. If you’re unsure which paver line your driveway uses, flip a loose unit and look for a stamped code on the underside. That code tells us the series, color batch, and production plant. We cross-reference that against current Belgard and Unilock equivalents when an exact OEM match isn’t available. Aftermarket equivalents are fine for this application when they’re from a documented manufacturer and rated for vehicle traffic, which we confirm before any quote. Bradford Remodeling Co San Francisco is an independent service provider, not affiliated with Dvele, but we service their hardscape packages regularly and keep the common sizes in our yard.

Explore

Styles & brands we work with

Kitchen remodeling
Kitchen remodeling
Bathroom remodeling
Bathroom remodeling
Home additions & ADU
Home additions & ADU
Roofing
Roofing
Windows & doors
Windows & doors
Driveway & pavers
Driveway & pavers
Fence
Fence

Signs Your Dvele Driveway & Pavers Are Failing

  • Paver settling near the garage apron. This is the first failure point in San Francisco because the apron takes the most load and the most surface water. The cause is almost always a compacted base that was never deep enough for the soil conditions, not a bad paver.
  • Polymeric sand washing out between joints. You’ll see gaps opening up and sand collecting at the low end of the driveway after rain. Left alone, the pavers start shifting laterally and the surface loses its interlock.
  • Water pooling against the foundation line. If water sits against the slab or the garage stem wall for more than an hour after rain stops, the paver base is holding water instead of shedding it. In the Outer Sunset, where fog keeps everything damp nine months a year, this shows up faster than anywhere else in the city.
  • Edge restraints pulling loose. The plastic or aluminum edge that holds the paver field in place starts heaving or separating. Once the edge fails, the outer course of pavers wanders and the whole field loosens.
  • Visible cracking or chipping on the paver surface. Concrete pavers made in San Francisco’s damp coastal air can spall if the mix had excess water at production. A few chipped units is cosmetic; a pattern of spalling across the field means the units were never rated for driveway loads.

Replacement Cost & What’s Included

A finished backyard cottage with a small covered porch

In San Francisco, a full paver driveway replacement runs $8,260 to $21,240 depending on square footage, access, and what’s under the existing surface. Here’s the honest breakdown of what drives the number:

  • Excavation and base work: $2,000 to $6,000 depending on whether we’re removing an old concrete slab or re-grading over existing base material. San Francisco’s clay soil usually needs 8 to 12 inches of compacted aggregate, not the 6 inches some builders get away with inland.
  • Paver material: $4 to $9 per square foot for Belgard or Unilock units rated for vehicle traffic. Legacy Dvele-compatible sizes cost a bit more because we have to match the module.
  • Installation labor, sand, and compaction: $3 to $6 per square foot. This includes the edge restraint, geotextile fabric, and jointing compound rated for wet climates.
  • Drainage correction: $500 to $2,500 if we’re adding a channel drain or regrading the slope. This is the line item that separates a 5-year driveway from a 20-year driveway.

Every Dvele driveway or paver project we run through Bradford Remodeling Co San Francisco gets a written price before work starts. Not a range. Not an estimate you have to trust. A line-item number, and if the scope doesn’t change, neither does the number. The 365-Day Done Right Promise covers the completed hardscape for a full year from close-out. If a paver shifts or the sand washes out inside that window, we come back and correct it. No charge, no argument, no invoice.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

DIY or Call Us?

A homeowner can safely inspect a Dvele driveway and identify what’s failing. Check the joints for missing sand, check the edges for movement, and watch where water goes during a rain. What a homeowner should not do is start pulling pavers and re-compacting base material on a driveway that carries vehicle weight. The compaction requirement is specific, and San Francisco’s clay soil behaves differently than the sandy soil most DIY videos assume. Get the compaction wrong by a few percent and you’ll be resetting the same pavers next spring. The other hard truth: paver replacement done wrong damages more than the driveway. A poorly drained base pushes water toward the foundation, and that’s a much more expensive problem than the paver quote. If you want to handle the inspection and leave the fix to us, that’s a reasonable split. We’ll confirm what you’re seeing, give you a written price to correct it, and have it square before the next real rain. Call (831) 610-5598 and we’ll look at it.

FAQs

A single-story rear room addition with tall windows and a new patio

Get a Straight Number on Your Dvele Driveway

If your Dvele driveway is settling, washing out, or losing its edge, we’ll give you a written price that covers the full scope: base work, drainage, pavers, and the guarantee. No numbers that move at the door. Curtis Lane runs the close-out on every hardscape project we take, and the 365-Day Done Right Promise means the work holds or we come back. Call (831) 610-5598 to schedule your free estimate. Straight number, real scope, no surprises at close-out.

Written by Curtis Lane, Owner, Bradford Remodeling Co – San Francisco, CA at Bradford Remodeling Co San Francisco, serving San Francisco and nearby areas.

Getting started with Bradford in San Francisco

Every project starts with a conversation and a written price. Here is how to take the first step.

A project lead measuring a kitchen with the homeowner during a free estimate

Free on-site estimate

A project lead walks the job with you, measures it and hands you a written, line-item price. No obligation.

Book an estimate
A remodeling crew arriving at a home with lumber and tools

Your San Francisco team

A local crew that works across San Francisco and the towns around it, to the same written standard as every Bradford location.

Areas we serve
A worker laying floor protection and a dust barrier before work starts

Read our written promise

What we promise on every job, written down, with the terms spelled out before any work starts.

Our promise
Need Construction help in San Francisco? Licensed & insured · Free written quotes response · free estimates
Call (831) 610-5598
Areas We Serve

Request a Free Estimate in San Francisco

Tell us what you need - Bradford Remodeling Co San Francisco responds fast. No obligation.

By requesting your free estimate, you agree to the terms of our Privacy Policy and consent to receive communications by phone, text, or email concerning your request, including by the partner businesses that may perform the service.

Prefer to text? Text Us
Call Now - 24/7 Dispatch